ZEPHIR

®

(see diagrams 8 and 9). ? Dealing with openings
overhang 10 cm max tile / railflat-head fastener As a general rule, the junction Zephir/joinery is dealt with metal frames fixed to the bearing structure or to the secondary frame, and either overlapping or butting the panels. > Jambs
DEALING WITH IRREGULAR POINTS ? Angles In order to make square angles between two verti- cal pieces, in case of external angle, it is necessary to eliminate the longitudinal lips on the section of the tiles manufacturers in the over layer. Two points of mastic are used for the assembling. External angles can also be dealt with by using a metallic or PVC section overlapping the angle formed by the 2 tiles
metalframework maximum overhang = 10 cm tile / railflat-head fastener fixing plugscrew DIRECT INSTALLATION WALL-CLADDING INSTALLATION external angle details external angle details Diagram 8 Diagram 9 metalframework A U-shaped 20 x 40 section, fixed on the jambs will house the section of the tiles inserted without their lips and fixed with mastic type Sikaflex Pro 11 FC . (see diagram 16) > Lintels
flat-headfastenerfree joint 5 mm maximum overhang = 15 cm rail / fixing holding bar free joint 5 mmoverhang 15 cm max tile / rail flat-head fastener holding bar The lintels can be dealt with in the same way as for the installation of the Zephir at the base of the work (start detail) > Sills
air layer The sills can be dealt with using a metal flashing, required in case of incorporating insulation (wall- cladding installation), or with a special Terreal masonry tile (tread nosing 30x30 with down edge). (see diagrams 14 and 15)
DIRECT INSTALLATION WALL-CLADDING INSTALLATION internal angle details internal angle details Diagram 10 Diagram 11 EXTERNAL ANGLEcutedINTERNAL ANGLE TREATMENT OF ANGLES principle of cuts to be carried out on site Diagram 12 Wastewater treatment plant, Neuville en Ferrain, FranceArchitect : Avant-Propos edition No.6 2005 72