| | | Panel add-ons are sized to fit flush to the end of the panel and the adjacent end cap fits beyond the end and flush with end trim When two panel add-ons are required side-by-side, the end cap is removed, and the two add-ons are flush | | When mounting panel add-on's in change of height configurations, the add-on must start a minimum of 3" from the edge Top trim width required below 24" are cut to size on site. The cut end should be applied against the adjoining panel, as the intermediate end trim will conceal the cut edge The Intermediate End Trim (UNTM) will interfere with the panel addon in an on-module configuration | | |