| | | Desk Top Screen (UNSDT) • A freestanding screen to be used for perpendicular territorial screening ' Intended to sit on the top of the worksurface but is not mounted, so is repositionable ' Matches 42" high datum line Can be used at the ends of worksurfaces, or between users anywhere along the length of the worksurface | | Desk Edge Screen (UNSDE) • A territorial screen that is mounted on- or off-module to the back or return edges of a worksurface and provides privacy at 42" high • Covers to 6" below the worksurface level to conceal cable management but will leave a 1" clearance between the desk screen and a low credenza for cable clearance Provides a casual fit with controlled gaps (actual width is 1" less than the nominal width) Can be used in combination with a modesty panel | | |
| | | Panel Wall Add-On Screen - Solid (UNSPS) and Home glass (UNSPG) • Available in glass or solid finish ' Can be on-module, off-module, or span two panel walls but cannot span a 180° spacer or 90° corner connection ' Replaces the top trim of the same width panel wall or in off-module applications, top trim in a minimum 3" increments will be required to finish the portion of the panel wall not covered by the add-on screen | | |
| | | • A 42" or 51" high visual screen that provides privacy to floor level and is mounted to a worksurface on- or off-module • Provides a casual fit with a 1" gap from worksurface • On back of a worksurface it is mounted offmodule and on the edge of a worksurface it is mounted on-module • Can be mounted to any back or return edge on a panel supported worksurface, except edges supported by end gables (open or with infill) or flush end gables • Does not provide support to the worksurface | | • Aluminum top rail can accommodate the Pencil Tray (PAX94), Media Organizer (PAX96), Vertical Organizers (PAX99, PAX100) and Workstation Signage (ACWS). Available from Complements: Teknions Ergonomics & Accessories program • A Wire Management Box that hides the vertical cable management between the floor and the underside of the worksurface can be specified separately, see Electrics section | | |