Catalogues - district

Catalogue District

www.teknion.com

Page

/ 133

Contact the
Manufacturer

Where to buy
this product ?

Request
a Quote

/ 133

See other catalogues for Teknion

Text version of the page

fascias

fascia basics

Fascia's complete the elevations of the panel walls, and are available with a variety of finishes.

Single

Upper Fascia

Window Single Glazed (UNEWS) and Double Glazed (UNEWD)

• Glazed fascias insert into the top segment of a District Panel Wall and always begin at worksurface height

• Cannot be applied to lower panel wall segment

• On-Module capability only

• Available to 60" width only to fit within the width restriction of a single frame (all garden panels wider than 60" are made up of two frames)

Upper Fascias-Solid (UNEU), Tackable Architectural fabric (UNEUT) and Whiteboard (UNEUW)

• Upper fascias are available in solid, whiteboard or tackable and begin at 29" heights

• See Finishes section for finish options

• An integral accessory rail at 36" high can be specified as an option on the solid and fabric options

• Tackable fabric Fascias are tackable only on upper portion above accessory rail

' On panels 66" wide or wider , the upper fascia can be split vertically, see application notes

13"-37" h

Tackable Fabric Fascia

Double

Whiteboard

22, 37" h

Power/Communications Fascia (UNEC) (North American) and (UNEIC) (International)

• Provides below worksurface access to panel/communication

• Available for both North American and International applications (see electrical section for specific electrical outlets)

• North American electrics are available in 2 configurations;

(2) one duplex outlet plus VDM (4) two duplex outlets plus VDM (available on 36" wide or wider)

• International electrics are available in 3 configurations;

(2) cut-out for two electrical outlets

(3) cut-out for two electrical outlets and one data/communicational box (available for 36" widths or higher)

Base Fascia (UNEB)

• The bottom of a panel wall without power communication cut-outs is finished with a Base Fascia (UNEB)

• The base fascia always mounts below height of 29"

• Elevated panel walls require a 23" base fascia only

• 29" base fascias can be applied to flush walls where support connection is not required at the base

• When access to the flush panel base is required for support connection, both a 6" high and a 23" high base fascias are required

• Fabric or contemporary windows cannot be applied to base fascia

24"-96"w

6", 23", 29" h

(4) cut-out for four electrical outlets (only available on 36" widths or higher)

• Various orientations are available

• (L) Left — not available on widths below

• (R) Right — not available on widths below

• (B) Both left and right — only available on 66" wide or wider for both one and two duplex options

• (C) Centered — only available on widths 36" and below for one duplex outlet and 36" wide for two duplex outlets

district application guide - September 17, 2007