Catalogues - district

Catalogue District

www.teknion.com

Page

/ 133

Contact the
Manufacturer

Where to buy
this product ?

Request
a Quote

/ 133

See other catalogues for Teknion

Text version of the page

panel walls

planning with panel walls

The following should be taken into consideration when planning with District Panel Walls.

District Panel Walls have no creep factor

For panel wall heights of 66" that do not support loads, the maximum unsupported run is 12'

For panel wall heights of 29", 42" and 51", that do not support loads, the maximum unsupported run is 16'

Support is provided by return garden panels, home storage or worksurface supports (see applicable sections)

Overhead storage must always be mounted in a corner

24" - 60"

66" - 96"

Panel Wall Widths

• Panel wall frames from 24" wide to 60" wide are made up of one frame

• Panel walls from 66" wide to 96" wide are made up of two equally sized frames

• Fascias are available in widths up to 96" and will span across the two frames or across two panels

• Panel walls are non stackable with the exception of windows furniture

Elevated Panel Walls

• Elevated panel walls require feet to be specified separately for end of runs and at 180° connections

• On 180° connections, only one foot is required and is located in a shared position

• When specifying any 90° panel wall connection a foot is included with the connection as specified


		J 1 E3 E3 1 II J

• The bottom of an elevated panel wall aligns with the bottom of elevated storage at 6" above floor level district application guide - September 17, 2007