Sunnex HT-Series – 20W Halogen

® ››› TECHNICAL DATA Lux table Main voltage: 230V/AC/50Hz or 12/24V AC/DC Nominal effect: 20W Class: II IP-Class: IP20
800 lux500 lux Equipped with: Electronic plug-in transformer 230V/12V/20WHalogen bulb – 20W/G4 ››› MOUNTING INSTRUCTIONS
402002040 cm 402002040 cm Mount the lamp on a horizontal surface with the four attached M4-screws.Hole pattern, see dimensional drawing on page 9.Available for the Gooseneck arm and Spot arm are also Sunnex mountingaccessories; Magnetic base, C-clamp, Wall bracket and Desktop base.Plug in the cordset to 230V main socket. On/off function is handled withswitch in lampbase.
Measured 0,4 meters from the light source. ››› NOTE ››› CHANGE THE HALOGEN BULB Use only Sunnex original parts to secure the function and performance ofSunnex lighting-series.If the lens is broken, it must be replaced by a new lens.Contact your local dealer if you are unsure how to handle replacementson Sunnex HT-Series. Disconnect cordset from main socket. Allow the bulb to cool down for a few minutes. Gently dismantle the front part of lamphead, pull out the brokenbulb and replace with a new bulb. Do not touch the b ulb with bare h ands!Push front part back on to lamp until it snaps in place. info@sunnex.se www.sunnex.com 8