Sunnex HF-Series – 50/75W Halogen

® ››› TECHNICAL DATA Lux table Main voltage: 230V/AC/50Hz or 12/24V AC/DC
50W75W Nominal effect: 50 or 75W Class: II IP-Class: IP20 or IP65 Equipped with: Electronic built-in transformer 230V/12V/50WHalogen bulb – 50W/GY6.35, 75W/GY6.35 (12and 24V only)
17000 lux3600 lux900 lux360 lux 27000 lux6000 lux1400 lux500 lux 402002040 cm 402002040 cm 402002040 cm 4020020 40 cm ››› MOUNTING INSTRUCTIONS
Measured 0,4 meters from the light source. Mount the lamp on a horizontal surface with the four attached M4-screws.Hole pattern, see dimensional drawing on page 15.Available for the Gooseneck arm and Spot arm are also Sunnex mountingaccessories; Magnetic base, C-clamp, Wall bracket and Desktop base.Plug in the cordset to 230V main socket. On/off function is handled withswitch in lampbase. ››› NOTE Use only Sunnex original parts to secure the function and performance ofSunnex lighting-series. If the lens is broken, it must be replaced by a new lens. The cordset inthis product is a non-replaceable type. If the cordset is damaged, the trans-former unit has to be replaced, and it should be done by the maufacturer or aperson with sufficient electrical knowledge.Contact your local dealer if you are unsure how to handle replacementson Sunnex HF-Series. ››› CHANGE THE HALOGEN BULB Disconnect cordset from main socket. Allow the bulb to cool down for a few minutes. Unscrew the front part of lamphead, pull out the broken bulb andreplace with a new bulb. Do not touch the b ulb with bare h ands! Screw frontpart back in place. info@sunnex.se www.sunnex.com 14