| Hoistway ■ A properly framed and enclosed hoistway, including any ventilation as required by the governing code or authority. ■ A dry pit constructed to the lift manufacturer's specifications to reinforce or sustain any vertical forces on the guide rails and impacted loads from the car and counterweight buffers. ■ A metal sill angle or concrete haunch across the full width of the hoistway at each elevator landing. ■ Provision of steel bars to fix jamb around the entrance of each floor. ■ All cutting, including cutouts to accommodate hall singal fixtures, patching, painting of walls, floors, or partitions, together with finish painting of front doors and frames, if required. ■ Provision of entrance or ladder for pit access ■ Supply and installation of fascia plate. ■ Installation of emergency exits and electric wiring in contemporary blind sections of hoistway where required. ■ The tolerance of perpendicular line over the whole hoistway height must not exceed ±30mm. ■ A waterproof outlet and light fixture in the elevator pit area with the light switch being located adjacent to the access modern door or ladder. ■ Suitable light fixture and convenience outlet in the pit with a light switch adjacent to the access door or ladder. The receptacles shall have protection for ground fault circuit interrupter. |