Turn-N-Slide Instructions, continued 4. Repeat Steps 2 and 3 for all rafters. 5. When all Turn-N-Slide sleeves are in their upmost position, pull the fabric corners and cables off the Turn-N-Slide hooks. Use wire ties or twine to tie the two cable loops protruding from each fabric corner together.This will prevent them from slipping into the hems while the canopy is being handled. 6. Pull the fabric canopy off the frame and lay on the ground. Fold into a 4’ square and store safely in a dry location off the ground. Do not stack anything on top of the canopy while in storage.7. To re-attach the canopy, unfold it on the ground next to the shade system. The canopy should be on the ground so that the Shade Systems sewn label is facing up. 8. Attach ropes to the protruding loops at each of the two corners of the canopy farthest from the structure, and throw the ropes over the frame so that they come down on the opposite side. Pull the ropes so that the canopy is hoisted over the frame. 9. Position the canopy so that each corner is near its corresponding Turn-N-Slide hook. Remove the wire ties used to fasten the loops together at each corner and pull the loops over the Turn-N-Slide hook. If your canopy corners were hooked on, attach them as well. 10. Reverse Steps 1 thru 3 above to re-tension the cables using the Turn-N-Slides, and store your hex-pinned allen key, along with these instructions, in a safe place to use next time. It is also recommended that the Turn-N-Slide threads are greased with each use.
Toll-free: 1-800-609-6066 www.shadesystemsinc.com e-mail: info@shadesystemsinc.com