RonaDeck EcoPath MT
4Pages

Aggregate and recycled rubber resin bound surfacing system SuDS compliant—highly permeable paving Natural aggregates Used rubber granules recycled from truck tyres Alternative to conventional paving Installed by approved contractors Description RonaDeck EcoPath MT is a resin bound aggregate surface for pedestrian traffic. RonaDeck EcoPath MT surfaces are decorative and functional, seamless and slightly flexible. The open matrix allows water to drain through to the base, eliminating water ponding and allowing water to drain to planted areas or land drains. The system is designed to be SuDS compliant reducing the impact of development on flood risk and allowing water to flow into water courses. Edgings created from brick, stone, timber or steel should be installed to retain and protect the resin bound surfacing. RonaDeck EcoPath MT comprises RonaDeck EcoPath MT Resin, a two component moisture tolerant epoxy resin which binds aggregate and recycled vulcanised rubber granules. The RonaDeck EcoPath MT provides an attractive surface, is strong enough for foot traffic, and is highly porous. RonaDeck EcoPath MT is typically applied to compacted Type 3 aggregate to provide a thin alternative to asphalt or concrete. RonaDeck EcoPath MT can be applied onto compacted soil. However, the drainage may be reduced and the system may be affected by soil washout, clay heave, flooding etc. Please consult the Ronacrete Technical Department for further information. Traffic RonaDeck EcoPath MT is designed for light foot traffic only. It is not designed for road surfacing, drives or car parks. Foot Traffic After 24 hours <® 20°C Aaareaate Some aggregates can contain small amounts of iron which can produce rust staining. This naturally occurring iron cannot be identified before use and Ronacrete cannot accept any responsibility for any loss or damage suffered as a Resin Bound and Bonded Surfacing Continued on following page... Other Ranges—Concrete Repair and Coatings, Screeds, Waterproofing and Tanking, and, Flooring and Beddi

RonaDeck EcoPath MT Aggregate and recycled rubber resin bound surfacing system Appearance The appearance of samples and of materials supplied by Ronacrete are based on the colour, shade and grading of individual aggregates supplied to Ronacrete by its suppliers. Being largely natural aggregates, the appearance will vary from bag to bag and batch to batch, a uniform appearance should not be expected and cannot be achieved. It is possible to repair localised damage by cutting out and replacing, ideally using the same aggregate as originally supplied. Ageing and weathering of the original may...

Aggregate and recycled rubber resin bound surfacing system Suggested Construction SuDS Sub-grade Compliant Permeable Construction for Footpaths The above information is produced for guidance only, the designer/ contractor (continued) should be satisfied that the construction is suitable for the expected traffic and ground conditions. Mix Design RonaDeck EcoPath MT Resin 6kg RonaDeck EcoPath MT Aggregate 75kg RonaDeck EcoPath MT Rubber Granules 15kg RonaDeck EcoPath Sand 7kg Coverage Coverage @ 35mm 2.4m2 (approx) Coverage is based on application to a smooth flat surface and will vary when...

RonaDeck EcoPath MT Aggregate and recycled rubber resin bound surfacing system Working Temperatures Working time is affected by temperature including material, air and substrate temperature. At temperatures above 25°C the pot life and working time may be insufficient to allow its proper application. Work should therefore not proceed when product, air or substrate temperature exceed 25°C. The temperature of the substrate must therefore be measured and monitored during application and work should stop when temperature is above 25°C. At low temperatures RonaDeck EcoPath MT Resin will not flow...