T2000 Mental Touch
2Pages

T ouch panel & Remote illustration Touch panel keys introduction FACILITY-Remote introduction Master on key (Lighting control) L1 output control key Master key L2 output control key L3 output control key Installation & Wiring Four group of device Remote key T2000 Light control touch panel Draw out the cables from BS4662 switch wall box and trim up, press tightly on terminal block as illustration Open the cover plate of touch panel from driving part with the screwdriver Dismounting hole Wiring terminal Wiring diagram for 2 way lighting Notice: Only the first gang (L1 ) can be used on 2 way lighting. Insert wiring terminal in driving section and cover the touch panel Mount the switch driving section into wall box and fix with 2 screws Ordering Information Current load Trouble Shooting Guide Possible cause 1.Wires are incorrect connected or not properly secured Backlight of touch panel does not illuminate The controlled equipment or 1.The voltage is not stable, and the power interference is strong lamps turn off automatically Touch panel flashes continuously Solutions Make sure that the input and output wire is well connected with the terminals, and the wiring is correct Connect the master switch and leakage protection occurs, please check whether there 2.Master switch or leakage protection switch is disconnected switch. If tripping still on the equipment or whether the is electrical leakage neutral line of output phase is correct 3.Protective tube burns out Current load Replace with a new protective tube of same parameters Stop to use the equipment of big interference and ask local technicians to check 1.Load current exceeds the rated operating current of the product. Reduce the load power, and then turn on the power. If the lamps still can not work normally, please change the driving part of the product Replace the touch panel 2.Touch panel is in the setting mode Exit the setting mode with Remote Touch panel cannot control 1.Incorrect wiring or connected with wrong terminal the correspondin lamps Check whether the lamp wire is connected to the output terminal correctly and correspond to the certain touch panel position HOTEL ROOM CONTROL T2000 Light control touch panel

T2000 Light control touch panel Icon and backlight indicator, clear at a glance Super-luxurious appearance, simple operation Applicable for electronic facilities required power on/off Product Overview Description T2000 Light control touch panel is featured by innovative design, convenient and simple operation. Super-luxurious appearance with LED backlight touch-types key, clear at a glance, and the design meets modern trends. It can also be easily identified at night.EEPROM can permanently keep parameters preset set by the user during power off. Applications T2000 Light control touch panel...