• Products
  • Catalogues
  • Projects
  • News & Trends
  • Exhibitions

ADC - 3 Pages

  1. P. 1

  2. P. 2

  3. P. 3

Catalogue excerpts

Reinforcement made of HR or stainless steel pipe the diameter of which is 27 mm and the thickness of which ranges from 3 to 5 mm; (Fig. 1). The anchor can be provided on one side with a pin or threaded casing (Fig. 2) . If needed the anchor can be bowed (Boomerang) .(Fig.3) Fabric sleeve wraps the whole anchor ; Injection pipe the diameter of which ranges from 8 to 10 mm is located in center of anchor and removable after injection ; its length is to be determined for accessibility through the nearest point; An injectable fix for spacing can also be used as a complement.(Fig. 1) Steel Anchors

 Open the catalogue to page 1

This type of anchor allows to hang prefabricated concrete or natural stone elements on concrete or masonry shear walls in all directions . Each anchor can bear up to 5 tons depending on the kind of steel used , the diameter of the anchor and the injected length in the support and the hanged element . The standard anchor can be provided with two injection chambers with non equal lengthes . The anchor can be installed on site or at the time of prefabrication , a reservation being foreseen in the bearing element. The anchor can be injected in all directions , in the space between the element (panel...

 Open the catalogue to page 2

Installation DRILLING 2 types réservations 2 types deof resevations : : A) Réservationsduring prefabrication of elementsdes éléments A) Casing left réalisées dans la fabrication à sceller en plaçant au blocks installed during to be hanges and puley moment de la construction des moufles dans les voiles supports . construction of the bearing wall (fig.1) . (fig.1) B) Par forage au moyen d’outils perforants ou diamantés B)By drilling with performing diamond tools . (fig.2) . (fig.2) Dans le cas de refroévoir toutes les In case of water cooling all necessary precautions prestations nécessairtion des...

 Open the catalogue to page 3

All M-TECH Patrimonium SA catalogues and technical brochures

  1. PIS

    4 Pages

    En
  2. PCCH

    4 Pages

    En
  3. AP

    2 Pages

    En
  4. AGL

    2 Pages

    En
  5. ARL

    3 Pages

    En
  6. AER

    2 Pages

    En
  7. AAT

    3 Pages

    En
  8. APL

    2 Pages

    En
  9. ABA

    2 Pages

    En
  10. AMC

    3 Pages

    En
  11. AM 2000

    4 Pages

    En
  12. Piles

    2 Pages

    En
  13. Steel anchors

    3 Pages

    En