• Products
  • Catalogues
  • Projects
  • News & Trends
  • Exhibitions

AAT - 3 Pages

  1. P. 1

  2. P. 2

  3. P. 3

Catalogue excerpts

(Pipe Anchor) Diam. 8/10/12/16/22 mm Concept Steel pipe made out of HR or stainless bossed steel pipe the diameter of which ranges from 8 to 22 mm the length of which varies according to the diameter from 1m to 6m; Sleeve covers the whole anchor  ; No injection pipe , injection through the reinforcement pipe ; Applications The use of AAT in small diameters and in large numbers is the ideal answer to stabilisation problems and to repairs of face elements made of prefabricated thin stone , of cladding , masonry walls .The AAT can also be used to inject grout or a strengthening product beyond the anchor to increase the resistance of loaded volumes and createa unloading arch. The AAT is often use to hang front elements on supporting walls (an hernia being formed in the ventilated space) , allowing a surface repair. The anchor works here better than a tie beam ( voir fig.A). ALTERNATIVES In restoration projects , bronze or fiber glass or carbon anchors can be used together with M-Tech grout. Fig. A Steel Anchors ANCRAGES ACIER

 Open the catalogue to page 1

KEYING le diamèt reet la Suivant BETWEEN PANELSlongueur de l’ancrage, IN produit WATERPROOF CONCRETE ce RIGID ORreste la réponse idéale aux problèmes de stabilisation et réparation d’éléments de parement, A very préfabrication recceded joints of mur de brique pierre,quick solution for mince, bardage, perfect aspect. etc…, en utilisant les petits diamètres en nombre comme In this case and according to the rabbet in the elements , desanchorss are made out of square section stainless steel pipes. les aiguilles. Un modèle particulier permet, après son placement ( see fig.B) conformément à la procédure...

 Open the catalogue to page 2

An inquiry on the quality of the support is néccessary the project consists in fastening or re-fastening .At the same time stresses by active loads shall be studied before répair as well as their directions. Gaps between the elements to be fastened by the anchors shall be known. It shall be determined as a function of the thickness of the anchoring whether the anchors should be designed with flats or a thread to tight a bolt. Numerous solutions are available upon request . Installation is easy and cheap . Positioning of the anchors shall follow the prescription. In a few cases positioning shall...

 Open the catalogue to page 3

All M-TECH Patrimonium SA catalogues and technical brochures

  1. PIS

    4 Pages

    En
  2. PCCH

    4 Pages

    En
  3. ADC

    3 Pages

    En
  4. AP

    2 Pages

    En
  5. AGL

    2 Pages

    En
  6. ARL

    3 Pages

    En
  7. AER

    2 Pages

    En
  8. APL

    2 Pages

    En
  9. ABA

    2 Pages

    En
  10. AMC

    3 Pages

    En
  11. AM 2000

    4 Pages

    En
  12. Piles

    2 Pages

    En
  13. Steel anchors

    3 Pages

    En