Automatic sequence of colours : Selection of nine colour sequence programmes. Each programme is defined by the lighting time of each colour and the transition time from one colour to another according to the following table: SEQUENCE ORDER OF COLOURS COLOUR TIMING BLENDING TIMING (SEC.) (SEC.) 1 Red Blue Green Purple Cyan Yelow 2 2 2 Red Green Cyan Blue Purple Yelow 4 4 3 Purple Cyan Yelow - - - 4 4 4 Red Blue Green - - - 8 8 5 Purple Cyan Yelow - - - 18 18 6 Yelow Purple Cyan - - - 0,5 0,5 7 Green Red Blue - - - 0,5 0,5 The colour or sequence is changed by pressing the pushbutton. The colour and sequence cycle is rotary. For example, if you are in colour 5, by pressing once, you will reach colour 6. If you press once again, you will go to sequence 7. If you are in sequence 7, press once and you will get to colour 2, which is Red. Colour 1, corresponds to white and is reached by one long press. 6.2. COLOR PLUS TOP: Receiver-Modulator control and/or Remote control The system has 21 operation modes: 12 set colours and 9 sequences of different colours (see section 6.2.2.). The Receiver-Modulator controls switching the spotlights on and off, changes of colour and sequences and switching off timing. If you have a remote control, apart from the receiver-modulator operations, you can also switch colours of a sequence on and off and select the switching off time. 6.2.1. Electrical connection diagram For correct installation, you will need the Receiver-Modulator, the transformer and finally the leds lamp. As an option, this system can be controlled by Remote Control. For more information on the installation of the Receiver-Modulator, see point 6.2.3. and section 6.2.4. includes information on the Remote Control. The Receiver-Modulator is connected to the 230 Vac mains by means of two terminals indicated MAINS, and to the primary input of the transformer (230 Vac) by means of the terminals indicated TRF (See attached diagram). Each Receiver-Modulator, it can control until a maximum of five spotlights. The transformer must have the capacity to supply 45 VA to each led spotlight connected. For example, if you want to control 5 lamps, they should be connected in parallel to a transformer of at least 270VA. Each Receiver-Modulator can control up to a maximum of 15 LED spotlights. Once the unit is connected, proceed as follows to start-up the projector for the first time: Switch on the unit by activating the 230 Vac. at the input of the Receiver-Modulator, which will automatically syntonize with the transformer. The green led of the Receiver-Modulator will flash every 2 seconds and the spotlight will remain off. Switching on the Remote control o Keep the OFF key pressed of the Receiver-Modulator. The green led will flash quickly indicating that it is in the Instruction mode. o Switch on the Remote Control and press any button. If you have several Remote Controls, repeat the operation so that the Receiver-Modulator acknowledges them all. There can be a maximum of eight. 6.2.2 Types of lighting The Remote Control – Receiver/Modulator – Transformer – Led Projector unit enables you to create different lighting settings inside the pool with two operation options: Set colour : Selection of a set colour among twelve possibilities.
4