|
KNX 2007 - 283 Pages
Synoptics
1
2
3
Ref.-No.
Electronic control module 2430 REG
Series embodiment (SE)-device (8 units)
In combination with the power supply 2447 REG the control module is used for controlling up to six signal or operator panels.
The module has an integrated BCU and interface to the KNX, therefore this device is the link between KNX and the synoptic modules.
The functions of the signal or operator panel KNX are programmed using the special EIBTAB-software. Only the physical address
(no application) has to be given with the ETS using the special dummy application (ETS-path: system components, line coupler).
249
4 Technical data
External supply
Voltage: 230 V AC
Connection: clamp bar
Bus supply
Voltage: 24 V DC (+6 V / –4 V)
Power consumption: max. 150 mW
Connection: KNX connection block
Operation temperature: –5°C ... +45°C
Storage temperature: –25°C ... +55°C
Mounting: onto DIN rail 35 x 7.5
-
P. 1
-
P. 246
244SecurityAccessories2 Ref.-No.Outdoor siren with flash light DAS 4110Rated voltage: 12 V DCProtection: IP 34Indoor siren DAS 4120Rated voltage: 10 –... -
P. 247
Accessories2452 Ref.-No.Surface mounted key switch, DAS 4300 AFor activating and deactivating of alarm systemsFront plate material: Pressure casted aluminiumFlush-mounted... -
P. 248
Synoptics123Ref.-No.Signal panel L 40 2405The KNX signal panel allows to monitor the actual operating states of an KNX system and consists of 40 LED.The... -
P. 249
12 Ref.-No.Blank plate, neutral 2415for flush or surface mounted panel boxes2474 Technical datas:External supplyVoltage: 5 V DCPower consumption: max.... -
P. 250
Synoptics123Ref.-No.Flush (U) mounted panel boxes 2422 U ... 2426 U12 Ref.-No.Surface (A) mounted panel boxes 2422 A ... 2426 AThe panel boxes are equipped... -
P. 251
-
P. 252
Synoptics123Ref.-No.Power supply 5 Vfor Signal/operator panel 2447 REGSeries embodiment (SE)-device (8 units)The power supply generates an output voltage... -
P. 253
VisualizationFacility-Pilot12 Ref.-No.Facility-Pilot FAPSoftware versionsPlanner version FAP-PLANER-GB50 data point version FAP50-GB300 data point version... -
P. 254
5 Visualization / Facility ManagementFacility Pilot – the new open visualisation generationThe JUNG Facility-Pilot is a flexible, interactive software... -
P. 255
5 Visualization / Facility ManagementWhen developing the system, attention was directed at economic efficiency since logic modules or year time switches... -
P. 256
Visualization / Facility ManagementTo this end, “virtual devices” are created on the screen, archives are defined, e-mail notifications and... -
P. 257
-
P. 258
-
P. 259
-
P. 260
-
P. 270
-
P. 280
