Catalogs >
HALTON >
HALTON-KSK

HALTON-KSK
6Pages

Catalog excerpts

20/KSK/xxxx/0306/EN KSK - Grease Filter Unit KSK Grease Filter Unit The KSK grease filter unit is mainly used for air exhaust for light-duty cooking, steamers, kettles and other processes with low heat emission levels. • High-efficiency grease filtration using UL- and NSFclassified KSA multi-cyclone filters - removing up to 95% of particles with a size of 8 microns or above • Exhaust airflow measurement and control using the in-built adjustment damper located in the extract spigot(s) and the T.A.B.™ testing and balancing tap • Stainless steel (AISI 304), welded construction

Open the catalog to page 1

20/KSK/xxxx/0306/EN KSK - Grease Filter Unit Construction The exposed parts of the casing are manufactured from polished stainless steel (AISI 304) and the unexposed parts from galvanised steel. The unit comprises duct connections, airflow dampers and a measurement tap. The joints of the lower edges are fully welded and polished to ensure water-tightness. The grease and dirt extracted by the filters can be removed from the filter unit either via a drain tap or by emptying the collection tray. DIMENSIONS KSK mm Length 500, 1000, 1500 Width 425 for wall model 825 for Island model Height 356...

Open the catalog to page 2

20/KSK/xxxx/0306/EN KSK - Grease Filter Unit Äpm2 Äpm2 Äpm2 Pressure drop and sound data, exhaust KSK/1 Äpm1 = Pressure loss of filters measured from measuring tap, minimum exhaust pressure loss when the damper plate is open Äpm2 = Maximum exhaust pressure loss when the damper plate is nearly closed. TP = Damper plate 0,1. = Numbers of blind filter Recommended pressure loss of filter Äpm1 35-120 Pa KSK-1000 KSK-1500 KSK-500

Open the catalog to page 4

KSK - Grease Filter Unit 20/KSK/xxxx/0306/EN Äpm2 Äpm2 Äpm2 Pressure drop and sound data, exhaust KSK/2 Äpm1 = Pressure loss of filters measured from measuring tap, minimum exhaust pressure loss when the damper plate is open Äpm2 = Maximum exhaust pressure loss when the damper plate is nearly closed. TP = Damper plate 0,1. = Numbers of blind filter Recommended pressure loss of filter Äpm1 35-120 Pa KSK-1000 KSK-1500 KSK-500

Open the catalog to page 5

20/KSK/xxxx/0306/EN KSK - Grease Filter Unit Suggested specifications General The filter units shall be constructed mainly from stainless steel AISI 304 except for the top panel of the plenum, which is to be of galvanised steel. The filter unit shall be supplied complete with outer casing / main body, pressure measurement tap, extract air spigot connections with airflow damper, grease filters, drain tap or collection tray and assembly brackets. Pressure measurement taps The pressure measurement taps shall be located on the side of the filter unit. Grease filters The grease filters shall be...

Open the catalog to page 6