Safety: Both leading and trailing door suppliers edges and framework are fitted with pneumatic safety edges that reverse the motor to re-open the door upon detection of an obstruction. The door fully opens to allow the obstruction to be removed after which it attempts to re-close, should the obstruction remain it will repeat the opening and closing sequence for sixty seconds after which time the booth controller ‘times out’ and sounds an alarm on the remote console. (One remote console is supplied as standard.) The torque setting of the door leaf is set at 8 to 12Kg, when a higher value is detected the leaf will slow down, stop and automatically reverse to the full open position. The motor is also fitted with over current protection should any obstruction be detected. Should a person remain within the booth for longer than sixty seconds, with the power switched off, the non-secure door will automatically open to allow the person to vacate the booth.

Installation Examples

Intercom : Mounted as standard on all models. Interface: The booth is controlled via a microprocessor activated by 0V contacts provided by a combination of, card reader, push button or radar device. As standard the following features are available; - ? Eight inputs ? Eight 0V programmable outputs of which three are used for entry, exit and passage confirmations. ? Two remote consoles. ? Alarm contact for telephone. ? One serial port for RS232. Note - The interface program can be customised, therefore it is important to confirm all interface requirements when placing an order. Power Supply: 115 or 230V AC 50/60Hz Power Rating : 330VA max. Control Voltage: 24V dc Installation: Internal or Semi External (under canopy), 150mm is required over the top of the booth for non routine maintenance/adjustment. Secure demountable over panel required if installed on wall centerline for access to electrical mechanical components during servicing. Servicing: Standard servicing is from the secure side of the booth via a lockable panel above the secure door. Temperature -10
O C to 55
O C Range: Model Nett Weight Packed Weight (Kg) (Kg) HiSec6 490 670 HiSec6LM 530 710 HiSec6B 650 830 HiSec6BM 690 870

………………………………………………………………

PDS/HiSec6/Issue 4 10-2004 2