Catalogs >
HEXDALLE >
PU 32 GLUE

PU 32 GLUE
2Pages

Catalog excerpts

PRODUCT DATA SHEET – PU 32 GLUE I. CHEMICAL BASE / APPLICATIONS Urethane prepolymer polymerizing with the humidity of the air. Diphenylmethane diisocyanate, isomers and equivalents 25-30% Single-component glue designed for sticking flexible materials such as: rubber fibres or granules (EPDM, SBR, BR, etc.), PU soft foams, expanded, extruded polystyrene. Gluing onto Concrete, Bitumen-coated material, Steel Plate, Aluminium For any glazed surface such as tiled floor, metal plate, aluminium, wood, make a resistance test before laying the rubber tiles and after sanding the surface II. PRODUCT PROPERTIES The polymerized film offers very good resistance to heat Solids content Viscosity at 20°C Brookfield RVT mobile n°3 / 10 t/min III. HARDENING The process starts at ambient temperature by a reaction with water vapour or with atmospheric humidity. A higher temperature and a high humidity rate shorten the setting time. The surface can generally be used 24 hours after laying. Total hardening time is between 3 and 5 days. During the hardening, the ground and air temperature should not fall below + 10°C. IV. RECOMMENDATIONS FOR USE The surface must be clean and dry, and free from any oil or grease. The base must be insulated from rising humidity and be more than four weeks old. Base: > 10°C and <4 to 5% humidity (carbide moisture tester). Ambient: > 10°C and <80% humidity. For information, the water content must be less than 3.5% at a depth of 10mm when checked with a Krüger 518 S-type tester and less than 4% at 20mm when checked with a Tramex-type tester. The glue must be applied onto the raised underside surface with the pourer (Cf. instruction sheet for laying) Do not apply to a wet base as the glue could foam significantly and fail to stick. Avoid soiling the surface of the tiles. The glue turns yellow as it dries. During the laying, the glue foams and seeps into the pores of the rubber conglomerate. Please note that if too much glue is applied, it will become visible as it dries. V. CONSUMPTION 400g for 1 sqm. Do not use too much glue. The quantities should be respected. Models, drawings and names are registered. No copy or reprography is permitted without prior written authorization. This manual was reviewed in June 2015 and may be updated; please make sure this is the latest version. FRANCE CONSTRUCTION Sols Sportifs et Techniques ZAC des Bousquets – 165 rue de l’Initiative – F-83390 CUERS TEL.: +33 (0)4 94 14 91 91 – FAX.: +33 (0)4 94 14 93 93 WEBSITE: www.hexdalle.com - E-MAIL: contact@hexdalle.com Page 1 out of 2

Open the catalog to page 1

VI. PRECAUTIONS Wear personal protective equipment. Take general protection and hygiene measures: keep away from food products, drinks and animal feed. Avoid any contact with the skin and the mucous membranes, and avoid inhalation. Immediately remove soiled or dampened clothes. Avoid any contact with the skin and the eyes. Protect hands by wearing gloves. Protect eyes by wearing airtight protection glasses. Protect the body by storing work clothes separately. Please read the safety data sheet before use. VII. OTHER INFORMATION Packaging The glue should be kept in a dry place and stored at a...

Open the catalog to page 2