Catalogs >
Elval Colour S.A. >
agraphon cleaning instructions

agraphon cleaning instructions
1Pages

Catalog excerpts

Necessary equipment • A mixture of alcohols, ethanol, butanol, N-butanol, isopropyl alcohol etc. • Water Pressure sprayer Graffiti removal steps Clean the surface with pressurized water (max 50 bar), for dirt removal. Warm water on metal surfaces helps in graffiti removal. The water temperature must not exceed 80°C. In the majority of cases most of the graffiti will be already removed with this step. If not, then follow the next step. Graffiti removal advice agraphorr coatings ELVAL COLOUR offers a wide colour range of agraphon* coatings that protect your building against graffiti. The special pigments make it easy to remove the graffiti from the surface. The agraphon® coatings can be PE, PU, VHDPE, VHDPU, Treat the graffiti with a mild alcohol mixture. Use a soft pad and mildly clean the surface. Make sure that the whole surface is treated. The alcohol must not be left on the surface for a long period of Use pressurized water for alcohol and graffiti removal from the facade. If the graffiti is not completely removed steps 1 to 3 must be repeated. The quickly cleaned facade from the graffiti will discourage the graffiti vandals from attacking the building again. Please note ELVAL COLOUR cannot be held liable for any damage caused on the facade by following the steps mentioned in this document, as we are not manufacturers of anti-graffiti removal products. We recommend a trial cleaning on a small area of the facade before treating the whole surface. ELVAL COLOUR 32011, Saint Thomas, Viotia, Greece

Open the catalog to page 1

agraphon cleaning instructions 1Pages

Catalog excerpts

All Elval Colour S.A. catalogs and technical brochures

agraphon cleaning instructions
1Pages