Catalogues > Berker > Berker Catalogue

Stand

Berker

Group: Hager Group

Products
Catalogues
News
Exhibitions

Berker Catalogue - 636 Pages

ISDN system

Sg bus lead

ISDN exchange line

"Normal" or cordless telephones with analogue connection

System telephones

Fax group 3

Pin assignment of FCC socket outlets

UAE 8/8

FCC 2x8 (4) with switohable resistors

FCC 8(4)

FCC 8

FCC 2x8 (4)

FCC 2x8

2b 1b 1a 2a 3 7 6 5 4 3 2"

2b 1b 1a 2a 6543

2b 1b 1a 2a 6 5 4 3

2b 1b 1a 2a 7 6 5 4 3 2'

2b 1b 1a 2a 7 6 5 4 3 2 1

71 5 3T 1

8 1

Notes on Cat. 5 and 6 cables

The twisted pairs must not be untwisted more than 13 mm, otherwise the transmission properties will change. For shielded cables connect the screen

Contact assignment FCC RJ45

■Terminal designation of FCC/pin

■-Pair

i-TIA/EI/

I Irי

-568-A IA-568-B igabit Ethernet

■ Analog terminal IEC

Analog Ana

terminal, Siemens log terminal, T-Com

■

10Base-T runshlelded

mnal

ilt. 2a/2b receive

TX+

I r

AS400

3bl2l2lX

TX-

RX+

TX-

(from Netw

mlnator NTBA;

2a|3|3|X

■UP0-ISDNtermlna

RX+

TX-

RX+

1a|4|4|X

TX+

TX-

TX+ U-R2a

1b|5|5|X

X-

X+

The bend radius " r " of the cable must not be less than 4 x the cable diameter "d" ( r > 4 x d

TX- U-R2a

2b|6|6|X

RX-

/ /

r > 4 x d

RX+

L Token Ring -3270

LDSL modem output 10Base-T and 100Base-TX Splitter output

I8!8

RX-

LI-TP-PMC ATM

Wire colours when using installation cable J-Y (St) U 2x2x0.6 Lg

Network technology: Example of 4 terminals with switch 5 port, RMD with patch panel 6 port, RMD and FCC socket outlets

The application-neutral network for new Installations

In the case of a new installation, structures should be installed even now that will also reliably cover future applications. Therefore a data box will be required at all possible communication interfaces - both present ones and those conceivable in the future. These include not just the locations where telephone or PC applications will be operated, but also locations where television or video applications will be used later or music is desired. This installation is based on the central component, the patch panel 6-port, RMD in connection with classic FCC socket outlets 8pole shielded.

■ with auto sensing

The data rate of 10/100 Mbit/s is automatically detected for the relevant port

■ with auto negotiation

The data rate of 10/100 Mbit/s is automatically switched over for the relevant port

■ with automatic

mode switchover (Full/Half Duplex) at all ports

■ with auto-partitioning

Faults at the ports (internal and external) are detected automatically and the affected ports are switched off. The remaining ports continue to operate

with Ml Crosse, e.g. for

rossed patch cables can be used on every port as required. Special uplink ports ng, not required

®Patchpanel 6 Port REG Patch panel and FCC socket outlets

1996 with LSA+ connecting terminals

■ Cascadable as required (4096 IP addresses;

with more than 5 terminals in the application, multiple switches can be interconnected with no loss in performance

Up to 4096 terminals in a system can be managed using these switches

■ Store and forward principle

The most up to date method of switching.

The data received is initially buffered in the device and only forwarded when complete Defective data is therefore detected at this point and is not forwarded. This does not unnecessarily increase the data load on the system.

To other switches/PC

Designation	LED = ON Function:	LED = OFF3 Function:	LED = Flashing Function:
LED 1 (gr)	10 / 100	100 Mbit/s	10 Mbit/s	-
LED 2 (yel.)	FDX /COL	Full Duplex	Half Duplex	Collision1
LED 3 (gr)	LINK / ACT	UP-Link	Down-Link	Activity2

AIn order to meet the general safety regulations for telecommunications systems and prevent interference, DIN VDE 0100 Part 520, Section 12 must be observed For unsheathed insulated single leads, a distance of < 10 mm must be maintained between signal leads and power leads.

No function at this port

Device transmitting / receiving data

All LEDs off = no power supply / device defective

P. 1
P. 596
RADIO BUS CONTROLLER/SYSTEM Radio controller 180 flat The radio controller 180 flat with integral brightness measurement allows the extension...
P. 597
SCH UKO SOCK ET OUTLET WITH RCD/ RESIDUAL CURRENT DEVICE SCHUKO socket with RCD protectio switch to VDE 0664 Use in the entire household has...
P. 598
ANTENNA TECHNOLOGY Antenna technology terms Tap: for connecting one or more branch cables to a continuous trunk cable. The level of the branched...
P. 599
ANTENNA TECHNOLOGY/ DATA COMMUNICATION SAT aerial system with 2 squinting single universal LNBs e.g. for Astra and Eutelsat reception...
P. 600
VGA module The VGA module is used to connect display devices to a graphics card. VGA cables can, depending on their quality, even at lengths of less...
P. 601
P. 602
Berker Router with DSL modem RMD in a network, ADSL analog Internet access service (transmission speed 768/1500 kB/s) Network operator ...
P. 603
B. Berker DIMENSIONAL DRAWINGS MODUL 2/BERKER S.1/B.1/B.3/B.7 GLAS MODUL2 3gang L = 222,5 mm f~ 4gang L = 293,5 mm 5gang L = 364,5 mm r i x Rocker 52 71...
P. 604
DIMENSIONAL DRAWINGS SERIE 1930 PORZELLAN MADE BY ROSENTHAL/SERIE 1930/GLASSERIE/PALAZZO/SPLASH-PROTECTED FLUSH-MOUNTED IP44/TWINPOINT SERIE 1930...
P. 605
DIMENSIONAL DRAWINGS BERKER K.1/K.5/ARSYS/BERKER TS BERKER Q.1 3gang L = 222,5 mm 4gang L = 293,5 mm 5gang L = 364,5 mm □...
P. 606
DIMENSIONAL DRAWINGS BERKER TS SENSOR/B.IG/SURFACE-MOUNTED lilt Il II IDI Ж 1" 1 ti t! T i 1 ^d!..... , ""fi...
P. 607
P. 608
P. 609
P. 610
P. 620
P. 630