338/390 Specifications

A. UNIT FEATURES

1. All pivot plates and handle hardware shall be extruded alum inum , finished to m a tch the unit. Plated hardware is not perm itted. 2. Pivot and strike jam b s to have continuous vertical vinyl seal. 3. All architectural doors to have continuous drip rail and vinyl wiper blade at bottom of door panel. Drip rail will be sloped to drain water to the interior of the door when opened. Installation of the drip rail is by double-si ded foam tape. Mechanical fasteners are perm itted. 4. Vinyl drip wiper is fully adjustable for precise fit to curb. 5. Doors to be adjustable f o r precise f it to wall conditions. Optional strike side f illers are available for extrem e out-of-plum b wall conditions. 6. Latch to be perm anently m ounted m a gnetic garden strips. Mechanical closure devices not perm itted. 7. Pivot side adjustm e nt is !" . 8. Curb design allows attachm e nt to base w ith double sided foam tape (supplied), sealant, or adhesive. 9. Side panels (391, 395), return panels (392), neo angle units (394), and custom configurations available with Alum ax Stik Stall applications. (See separate StikStall specifications). 10. Detailed instruction sheets and cross sections with custom unit fabrication form ulas.

11.

24 hour product inform ation and support via the Alumax Bath Enclosures Website (www.alum axbath.com ).

B. UNIT VALIDITY

1. W e t test: All joints, seam s, and seals are tested and evaluated for leaks in a wet test m odule. 2. Mechanical test: Moving parts or com pone nts subject to wear are cycle tested to sim u late 20 years of use. 3. Artificial aging: Plastic com ponents are selectively tested by artificial aging. This process subjects the parts to ultraviolet light, heat, and hum idity to test the resistance of the m a terial to these conditions. 4. Quality is assured by various in house verification procedures.
6-16-04