Text version of the page 
Fastening
KeraTwin K12 35
5. Alternatively to the method described in item 4, or for thefastening of single panels, the terminal-clamp can also be
used. In this case, only the base plate of the KT clamp is
fastened to the bearing profile in accordance with the
vertical grid. After the KeraTwin panel has been inserted, a
separate clamp lip can be pressed in the base plate and a
lateral hole of the KeraTwin panel. For further information, see the standard technical details of thesystem K12 which we will make available to you upon request.
Mounting instructions for KeraTwin K12(clamp fastening KT)
Substructure 4. Atthe last row, the edge-clamps are fastened as describedunder item 1 so that the area can be completed. Two verti-
cal rows have to remain open. Two single-clamps are
placed between two panels, one panel of the pair of panels
is inserted into the already mounted twin-clamps, the other
panel into the pre-assembled edge-clamps, pressed with
the inserted clamps to the bearing profile, adjusted in
height, drilled and fastened by means of stainless steel
blind rivets. The mounting of the substructure must be carried out accordingto project-specific, static calculation. The profiles have to be
mounted perpendicularly and in a flush way. The distance of the
rails in horizontal direction must correspond to the longitudinal
grid of the panels. Important: aprofile butt joint of the vertical bearing profilesbehind a panel is not allowed! See standard technical detail
drawings. K12 with KT stainless steel clamps on vertical bearingprofiles1. The edge clamps are fastened to the bearing profile bymeans of stainless steel blind rivets* in accordance with the
vertical grid of the panels. (For the arrangement of the
clamps, see the sketch on page 34) 2. Four self-adhesive foamed pieces are used per panel.Mounting between panel and bearing profile. 3. The panel is put in pre-assembled KT clamps, two single-clamps are inserted on the other side; adjustment in
height, drilling and fastening with stainless steel blind rivet.
This process is repeated in vertical or horizontal direction.
KeraTwin *Stainless steel blind rivet ø 3.2 x 8 mm with 58 mm grip. Use a mounting tool withextended mouthpiece!